 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
JOMY® Balcony Specification Guide
This section is based on products distributed by JOMY® Safety Products Inc., at the following address:
4635 Nautilus Court South
Boulder, CO 80301
Tel: (303) 527-2700
(800) 255-2591
Fax: (303) 527-2800
JOMY Balconies are intended to supplement access to the JOMY Safety Ladder where required by code or other safety considerations.
PART 1. GENERAL
1.1. SECTION INCLUDES
Access Balconies
1.2 SUBMITTALS
A. Submit under provisions of Section 01300.
B. Product Data: Provide manu-facturer's standard details and catalog data demonstrating compliance with referenced standards. Provide installation instructions.
C. Shop Drawings: Submit drawings illustrating layout and anchorage of balconies.
D. Warranty: Submit manufacturer's standard warranty.
1.3 DELIVERY, STORAGE, HANDLING
A. Store products indoors and protect from moisture, construction traffic, and damage.
1.4 WARRANTY
A. Manufacturer's standard warranty against defects in materials and workmanship; 10 year period.
PART 2. PRODUCTS
2.1 MANUFACTURER
A. Provide products fabricated by the
JOMY Safety Products, Inc.,
4635 Nautilus Court South,
Boulder, CO 80301.
Tel: (303) 527-2700
(800) 255-2591
Fax: (303) 527-2800
2.2 MATERIALS
A. Balcony Frame: 6063-T6 aluminum alloy.
B. Balcony Rails: Extruded aluminum, 6063-T6 alloy.
C. Brackets: 6063-T6 aluminum alloy.
D. Pop Rivets, Bolts, Masonry Bolts, Fasteners: Stainless Steel
E. Restraining Chain: Nylon coated filament.
2.3 BALCONIES
A. Provide aluminum balconies at locations indicated on the drawings.
B. Size: 24 x 42 inches, nominal (OR) 38 x 42 inches, nominal (OR) Custom size as indicated on the drawings.
C. Rail: 42-inch 2 sides, restraining chain 1 side (OR) 42-inch 2 sides, pass-though gate 1 side.
D. Capacity: 100 lbs. per sq. ft.
2.4. ACCESSORIES
A. Provide brackets, spacers, etc., necessary for a complete installation.
B. Contractor to provide fasteners for securement to wood construction: Stainless steel lag bolts; 3/8-inch diameter, 4-inch minimum embedment.
C. Contractor to provide fasteners for securement to steel construction:
Stainless steel bolts, nuts, and washers; 3/8-inch diameter.
2.5 FINISHES
- 1. Color: As selected from manufacturer's standards
- 2. Color: Match paint sample supplied by architect.
A. Aluminum: Clear anodized.
B. Manufacturer's standard shop-applied enamel.
PART 3. EXECUTION
3.1 EXAMINATION
A. Verify that wall surfaces to receive units are complete and approved prior to installing work of this section.
3.2 INSTALLATION
A. Install components in strict compliance with manufacturer's instructions.
3.3 ADJUST AND CLEAN
A. Remove debris; leave project site in clean and orderly condition.